Dewalt DCF815S2 12V MAX Cordless Lithium-Ion 1/4 in. Impact Driver Kit

Model: dewndcf815s2
ratings        (41) Write A Review

This item is temporarily out of stock. Want an email when it’s back in stock?

OUT OF STOCK
CA Residents
Prop 65 Warning
compliance warning icon
WARNING: This product can expose you to Lead, which is known to the State of California to cause Cancer and Birth Defect/Reproductive Harm. For more information go to www.P65Warnings.ca.gov.
Dewalt DCF815S2 12V MAX Cordless Lithium-Ion 1/4 in. Impact Driver Kit Model: dewndcf815s2

Product Features & specs :

Dewalt DCF815S2 12V MAX Cordless Lithium-Ion 1/4 in. Impact Driver Kit

Details Features:
  • Compact and lightweight design; weighs only 2.3 lbs. and can fit into tight areas
  • Three LED lights provide visibility without shadows
  • One-handed loading 1/4 in. hex chuck that accepts 1 in. tips
  • Belt hook included for portability
  • Rubber bumpers allow tool to be laid down without marring surfaces
  • Forty minute charge time
  • Includes two 12V MAX 1.5 Ah Lithium-Ion Batteries
What’s Included:
  • 12V MAX Cordless Lithium-Ion 1/4 in. Hex Chuck Impact Driver Kit - DCF815S2
  • (2) 12V MAX Lithium-Ion Batteries - DCB120
  • 12V MAX 40-Minute Charger - DCB100
  • Bit Tip
  • Contractor Bag
Maximum Torque
950 in-lbs
Power Source
Cordless
Power Settings
1
UL Safety
Yes
CSA Safety
Yes
Wifi compatibility
No
Batteries Included
2
Battery Type
Li-Ion
Drive Size
1/4 in
Case Included
Yes
No-Load Speed (IPM)
3400
Case Type
Bag
Bluetooth Compatibility
No
Maximum Speed (RPM)
2450
Variable Speed Trigger
Yes
Battery Amp Hour
1.5 Ah
Voltage
12V
Motor Type
Brushed
Handle Type
Pistol
Drive Type
Hex
Charge Time
40 Minutes
Charger Included
Yes
ETL Safety
No
Battery System
12V MAX
Length
6 in.
Width
2 in.
Height
6.5 in.
Weight
2.3 lbs.
Warranty Term
3 Year

Reviews :

4.8 / 5.0
41 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
36
3
1
0
1
Would you recommend this product?
Yes (15)
Pros
Easy To Use (12)
Ergonomic Design (10)
Powerful (9)
Lightweight (6)
Best Uses
Frequent Use (5)
Small Projects (2)
Home Repair (2)
Jobsite (2)
Outstanding Performance
I've had this impact driver for a while usually used it for smaller task door, cabinets, light fixtures and such. My 20v impact driver got misplaced so just used what I had and this 12v impact driver went much farther than I would of ever imagined framed and decked porches never slacked up I wanted to see just how far it would go and after about 6 months it was a 4 inch screw securing a set of treated steps to the porch that literally made the drill go up in smoke in my hand this is one amazing tool
September 10, 2020
Originally posted at
Wonderful power in a very light weight tool
I love my 20v Max tools and when I need to work all day, I reach for them. But for everyday projects and repairs, this 12v Max impact driver is my go to tool. It is lightweight enough that I can use it over my head with no problem. The quick change bit makes it easy to swap between different types of bits as needed. I am loving it so much, that I am considering buying a 12v Max drill as well for those times when I need a tool with a chuck.
This review was collected as part of a promotion
May 31, 2020
Originally posted at
My daily sidekick!!
I have this with me all the time! Easy to use, great grip, power and very light. I am a beginner builder and still trying to add to my tool collection. So far I have built a storage bin for the porch, garbage bin, addition on barn, chicken coop and now a "she shed"!! I absolutely love it. I would recommend this for everybody!!!
This review was collected as part of a promotion
November 19, 2018
Originally posted at
Dewalt 12v Impact Driver: Compact & Powerful
About the DeWalt 12-volt Impact Driver.

I found (and then bought this tool [a Kit: DeWalt 12-volt Impact Driver / Drill / 2-batts / charger / bag] on a discount table about 4-5 yrs ago at HomeDepot.

I almost DIDN'T buy it.

The reason being, I hadn't used or ever seen - or at least noticed Impact Drivers being used by others in my trade; or for that matter the other trades (I'm an electrician). I knew that auto mechanics used pneumatic impact drivers/drills - that's it].

I was really ignorant as to what an Impact Driver was capable of doing. But because the price was too good to pass up, I 'took the chance' and bought it anyway.

After I purchased it, I don't think I even tried using it for a while; not being familiar with it.

But once I gave it a go...Wow! Was I glad I did! And very glad I decided to buy it!

Skipping everything else I could say about this little 12-volt champion; I'll just say that I rarely, rarely use my drills now...only when I really need to use one. Usually when I want to or need to use my older NON-quick change drill or Uni-bits. Otherwise, it is Impact Driver all the way.

Recently I bought the 20-volt DeWalt Impact Driver & Drill Kit (discounted again from HomeDepot). The 20-volt naturally has more power than my 12-volt, and I do use it. But for my particular needs, I find myself mainly using the 12-volt DeWalt Impact Driver to accomplish most of drilling and driving needs.

Why? It is lighter in weight and more compact than all my other drivers and drills; and yet has more than enough power and endurance to handle the bulk of my needs for any given project during any given day.

I really don't use the supplied handle, but bought the 'loop' holder that clips to my tool belt, and I'm off to the races.

Lastly, besides the DeWalt 12-volt & 20-volt Impact Driver / Drill Kits; I have the Rigid 18-volt Impact Driver / Drill Kit; and the Milwaukee 18-volt Rigid Impact Driver / Drill Kit; as well as a 12-volt Rockwell Impact Driver.

Out of and above them all, I find myself using and preferring to use this 12-volt compacted power house: the 12-volt DeWalt Impact Driver. The 20-volt DeWalt is next in line; the Milwaukee and Rigid about even; and I never use the Rockwell anymore (lacks power; speed and will not hook to the belt looped hook).

In addition. I rarely use any of the drills that came in the kits. The drills I use the most up to this point have been the 12-volt & 18-volt Milwaukee Hammer Drills for drilling into concrete.

Well done DeWalt.

Now about LOOSING BITS:
Yes. Sometimes my quick-lease bits are ejected from and go falling to the floor from my ladder. Meaning, at times, when I have NOT BEEN CAREFUL, and I place the nose of my Impact Driver into those holes supplied in the top of my ladder. The quick-release mechanism can get caught and it CAN eject the bit onto the floor.

Yes. It is annoying when it occurs. Its rather rare, though, I get it caught that way. I've learned to be careful not to just JAM the Driver INTO the ladder hole (or with some quick release mechanisms, if you YANK IT OUT of the ladder hole without being careful). But for me, even not being that careful, rarely does it get caught in such a way that it expels the bit.

Another worse scenario: Being in a HOT ATTIC for example. While drilling, say, a hole down into the top plate of a wall with my Impact Driver. If while PULLING the Impact Driver's nose UP out of the hole; I fail to be conscious NOT to allow the Drivers Quick Release mechanism to get hung up on the side of the newly drilled hole I made. I may end up seeing (or hearing) my favorite bit goes plummeting down into the wall (perhaps, never to be seen again).

Yes. That is more than annoying! It has happened to me. Yet for me, many of the times this has occurred to me I have been able to retrieve a 'lost' bit with a powerful magnet on a string or rod (but not always). It is rather rare though, that this has happened to me over the years.

DRILL vs DRIVER:
And frankly, it has occurred more often with a DRILL, where the bit has come loose during drilling. It might not be loose enough not to continue drilling; but loose enough, that after cutting all the wood away (that was keeping the bit from falling) - there goes the bit!

All in all though. I trust a quick release mechanism, more than a drill chuck to keep me from loosing a bit. I'm just very careful if and when I may need to stick the quick release mechanism of the nose of my Impact Driver into the hole in the wood, drywall, metal or otherwise...PLUS, I carry an extra bit with me just in case. I often say to others or a helper, "Take an extra one of those [whatever bit or part]: One to drop or loose; one to use." Murphy's Law is ever present. But sometimes you can out wit it...sometimes.
This review was collected as part of a promotion
November 18, 2018
Originally posted at
Very Torque'ie
This tool has so much power that it will drive a four inch deck screw with little effort.
And that means it will do the job many times before the battery has to be changed out.
This review was collected as part of a promotion
November 13, 2018
Originally posted at
Best purchase ever!!!
Love this little thing. Works great for needing power and needing to get into small spaces. I use it in wood working, mechanics,etc and it always gets the job done. Couldn’t be happier with this purchase
This review was collected as part of a promotion
November 13, 2018
Originally posted at
Looses bits
I had this tool for about a year and hate it. The bits fall out. I lost two yesterday when they fell into deep insulation while working in my attic. I also spent an inordinate amount of time chasing them down into the gutters while working on my roof last year. Just buy two drills and a bit holder.
September 19, 2018
Originally posted at
Great tool
Works great for what I need it for. I use it everyday in my Home Repair Company
May 7, 2018
Originally posted at
Would you recommend this product?
Yes
Pros
Easy To Use
Ergonomic Design
Powerful
Value
Battery Longevity (if applicable)
Lightweight
Best Uses
Small Projects
Home Repair
I would definitely recommend this DeWalt tool. It is the best DeWalt tool. Lightweight easy for a woman like myself to use. Thank you for having this in your store. Easy shopping quick shipping fantastic website
April 23, 2018
Purchased
over 2 years ago
Would you recommend this product?
Yes
Pros
Easy To Use
Value
Lightweight
Best Uses
Jobsite
I would recommend this drill to anyone wanting a small yet strong and light weight drill !!!! Easy to use and fast on recharging!!!
March 30, 2018
Purchased
over 2 years ago
Describe Yourself:
Professional

Q & A :

Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 2 questions Browse 2 questions and 1 answer
Can it get wheel nuts of ties with ease pluse it differently comes with batterys
nola on May 15, 2015
BEST ANSWER: That unit does come with 2 batteries, I would not recommend the Dewalt dcf815s2 to remove lug nuts.
does this work under water?
A shopper on Apr 12, 2017

Warranty:

Most DEWALT® Tools purchased on or after January 1, 2004 come with a warranty package that includes:

Three-Year Limited Warranty. DEWALT will repair, without charge, any defects due to faulty materials or workmanship for three years from the date of purchase. This warranty does not cover part failure due to normal wear or tool abuse. For further detail of warranty coverage and warranty repair information, visit www.dewalt.com or call 1-800-4-DEWALT (1-800-433-9258). This warranty does not apply to accessories or damage caused where repairs have been made or attempted by others. This warranty gives you specific legal rights and you may have other rights which vary in certain states or provinces.

One-Year Free Service Contract. DEWALT will maintain the tool and replace worn parts caused by normal use, for free, any time during the first year after purchase.

90-Day Money Back Guarantee. If you are not completely satisfied with the performance of your DEWALT Power Tool, Laser, or Nailer for any reason, you can return it within 90 days from the date of purchase with a receipt for a full refund - no questions asked.